Product ID:ENAMEL, WHITE 17875
MSDS Date:08/30/1993
FSC:8010
NIIN:00-286-7836
MSDS Number: BTZXL

DEL PAINT CORPORATION

3105 EAST RENO
OKLAHOMA CITY, OK 73117
US

Emergency Phone: 800-424-9300 CHEMTREC

Info Phone: 405-672-1431

Preparer: ONEY FLEMING

Cage: EO326

DEL PAINT MFG

OKLAHOMA CITY, OK 73117 US

Telephone: 405-672-1431

Cage: 39934

PETROLEUM DISTILLATES

CAS: 8002-05-9

RTECS: SE7449000

Fraction By Weight: 27.66%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM

XYLENE (SARA III)

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 0.24%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

NON-HAZARDOUS INGREDIENTS

Fraction By Weight: 72.10%

3.25 LB/GAL; 390 G/L

RTECS: 9999999VO

Routes of Entry: Inhalation:YES Skin:UNKNOWN Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYE CONTACT: IRRITATION, REDNESS,
TEARING, AND BLURRED VISION. SKIN CONTACT: PROLONG OR REPEATED
EXPOSURE CAN CAUSE MODERATE IRRITATION, DEFATTING, AND DERMATITIS.
INHALATION: NASAL AND RESPIRATORY IR RITATION, DIZZINESSS, NAUSEA,
& HEADACHE. INGESTION: CAN CAUSE GASTROINTESTINAL IRRITATION,
NAUSEA, VOMITING, DIARRHEA.
Effects of Overexposure:IF TLV'S ARE EXCEEDED SKIN CONTACT PRODUCES
REDNESS. EYE CONTACT PRODUCES REDNESS AND PAIN. INHALATION GIVES
LABORED BREATHING, DULLNESS, DROWSINESS, INGESTION CAN CAUSE
ABDOMINAL PAIN AND NAUSEA.
Medical Cond Aggravated by Exposure:DISEASES OF THE RESPIRATORY SYSTEM.

First Aid:EYE CONTACT: FLUSH WITH CLEAN, WARM WATER FOR AT LEAST 15
MINUTES, OCCASIONALLY LIFTING EYELIDS. SEEK MEDICAL ATTENTION. SKIN
CONTACT: REMOVE CONTAMINATED CLOTHING. WASH AFFECTED SKIN AREAS
WITH SOAP AND WATER. INHALATION: REMOVE TO FRESH AIR, ADMINISTER
OXYGEN IF NECESSARY, SEEK MEDICAL ATTENTION. INGESTION: KEEP PERSON
WARM, QUIET AND GET MEDICAL ATTENTION. DO NOT INDUCE VOMITING.

Flash Point Method:TCC
Flash Point:115F,46C
Autoignition Temp:Autoignition Temp Text:540F
Lower Limits:1
Upper Limits:6
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, OR FOAM. WATER MAY
SPREAD FIRE, USE WATER SPRAY ONLY TO COOL CONTAINERS EXPOSED TO
FIRE.
Fire Fighting Procedures:SCBA RECOMMENDED FOR FIRE FIGHTERS. WATER
SPRAY MAY BE USED FOR COOLING CONTAINERS TO PREVENT PRESSURE
BUILD-UP & AUTOIGNITION OR EXPLOSION WITH EXTREME HEAT.
Unusual Fire/Explosion Hazard:VAPOR HEAVIER THAN AIR. MAY TRAVEL ALONG
GROUND OR MOVED BY VENT & IGNITED BY PILOT LIGHT, OTHER FLAMES,
SPARKS, HEATERS, SMOKING, & OTHER REMOTE IGNIT SOURCES.

Spill Release Procedures:VENTILATE THE AREA. COVER SPILL WITH INERT
ABSORBENT MATERIAL AND SHOVEL WITH NON-SPARKING TOOLS INTO
CONTAINER. REMOVE CONTAINER TO A SAFE AREA AND SEAL.
Neutralizing Agent:NONE

Handling and Storage Precautions:STORE IN A CLEAN DRY AREA. KEEP AWAY
FROM FOOD PRODUCTS. KEEP AWAY FROM SPARKS, FIRE AND REMOTE IGNITION
SOURCES.
Other Precautions:KEEP CONTAINER TIGHTLY CLOSED. KEEP AWAY FROM
CHILDREN. ALL EQUIPMENT SHOULD BE GROUNDED TO REDUCE STATIC
ELECTRICITY HAZARD. USE NON-SPARKING TOOLS.

Respiratory Protection:IF TLV OF THE PRODUCT OR ANY COMPONENT IS
EXCEEDED, USE A RESPIRATOR WITH APPROPRIATE CARTRIDGES (NIOSH
APPROVED). ENGINEERING OR MANAGEMENT CONTROLS SHOULD BE IMPLEMENTED
TO REDUCE EXPOSURE.
Ventilation:LOCAL EXHAUST MUST BE SUFFICIENT TO KEEP AIRBORNE VAPOR
CONCENTRATIONS BELOW THE TLV LIMIT.
Protective Gloves:CHEMICAL RESISTANT GLOVES
Eye Protection:SAFETY GLASSES WITH SIDE SHIELDS
Other Protective Equipment:SOURCE OF CLEAN WATER SHOULD BE AVAILABLE IN
WORK AREA FOR FLUSHING EYES & SKIN. WEAR IMPERVIOUS CLOTHING AS
NEEDED.
Supplemental Safety and Health

HCC:F4
Boiling Pt:B.P. Text:300F,149C
Decomp Temp:Decomp Text:752F,400C
Vapor Pres:2.58
Vapor Density:> AIR
Spec Gravity:1.23 (WATER=1)
Viscosity:77-86 KU
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NO
Appearance and Odor:WHITE LIQUID WITH MILD ODOR
Percent Volatiles by Volume:45.97

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:DO NOT STORE NEAR HEATED SURFACES, OPEN
FLAMES OR IGNITION SOURCES.
Hazardous Decomposition Products:THERMAL DECOMPOSITION MAY YIELD CARBON
DIOXIDE.

Waste Disposal Methods:WASTE MATERIAL MUST BE DISPOSED OF IN ACCORDANCE
WITH FEDERAL, STATE, AND LOCAL ENVIRONMENTAL REGULATORY CONTROLS.
HAZARDOUS WASTE CHARACTERISTIC: IGNITABILITY. EPA HAZARDOUS WASTE
CODE: NONE.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.